Autometer Water Temp Gauge Sending Unit. If you have a full sweep electric. like the 5754. that would require the 2252 sender. Gauges made by autometer. for as low as $23.99.
2018 1/8 NPT Temperature Temp Sensor Water Oil Unit Sender aliexpress.com
Hi. this 2385 sender is specific for our auto gage electric water temp gauges. The sender supplied with the water temperature gauge is part #2258. Theyre available in different thread sizes. and.
Source: bestboatingsupplies.com
Autometer recommends replacing this sender with their part # 2259 which is a shorter sender. In addition. the shoulder does not tighten up properly.
boeseengineering.com
Testing a water t emp sender for correct resistance. Gauge diameter (in.) and get free shipping on orders over $99 at summit racing!
aliexpress.com
Gauge sending unit. fuel level sender. electrical. 240 ohms empty. 33 ohms full. lever type. each. You can use an infrared handheld device which is probably the best way.
aliexpress.com
Autometer recommends replacing this sender with their part # 2259 which is a shorter sender. This sender can then be installed in the adapter.
aliexpress.com
The autometer mechanical water temp sending unit does bottom out in the aforementioned hole if you try to just use the blue collar. An autometer temp gauge will always need to be paired with an autometer sending unit.
speedwaymotors.com
Find autometer gauges water temperature gauge type. mechanical sending unit. 2 5/8 in. The sending unit is 1/8 pipe thread and the size of my 22r water temp guage is apparently m16 x 1.5.
The Red 5/8 Inch Adapter Provided With The Gauge Does Not Fit The Block Hole.
The oil pressure sending unit is different. but the water temp sensor is basically the same thing. The sending units are offered for more than a dozen gauge functions. including fuel. oil. water. boost. brake. oxygen. and nitrous data. This sender would be for the short sweep electric temperature gauge. like model 5737 or 5837.
I Would Guess That Your Autometer Gauge Is Not Hooked Up Cause If The Stock One Gets Unplugged Then The Car Will Not Start And Not Run Right.
A high water temp can be detrimental to an engine. In addition. the shoulder does not tighten up properly. Autometer 2258 sender and fittings for electric temp.
Gauge Diameter (In.) And Get Free Shipping On Orders Over $99 At Summit Racing!
If you have a full sweep electric. like the 5754. that would require the 2252 sender. The problem is i cannot seem to find an adapter to make this work. They offer senders for electric oil. fuel pressure. and electric temperature gauges.
Heat Is The Enemy Of Performance And Reliability.
Ive used the stock one. matter of fact im using the stock one now. An autometer temp gauge will always need to be paired with an autometer sending unit. The autometer sender uses a 1/8 npt.
Checking The Accuracy Of A Short Sweep Temperature Gauge (One That Uses A Single Terminal Sender):
Autometer recommends replacing this sender with their part # 2259 which is a shorter sender. You will need a n ohm meter. and a method of measuring the engine’s water temp other than the gauge sender you are testing. Gauge sending unit. fuel level sender. electrical. 240 ohms empty. 33 ohms full. lever type. each.